Advertenties
4 Technical data:
Motor:
Voltage:
Power:
Short-term operation:
Device:
Length:
Weight
(incl. connecting cable):
Spindle velocity:
Maximum polishing tool
diameter:
Noise development:
Please note that the sound and vibration measurements
in particular have been performed with Proxxon bits and
cutters. When using third-party brands we cannot guar-
antee compliance with the statements given here!
The following polishing tools are included in the scope of delivery of the WP/E angle polisher:
1 x
Polishing sponge
(blue=medium
hard, Article 28662)
1 x
Lambskin polishing
hood
(Article 28664)
1 x
Polishing felt disc,
medium hard
(Article 28666)
12 x
Super-fine grinding
disc, 2000 grit
(Article 28670)
A microfibre cloth (Article 28678) is also included with the WP/E for final cleaning of polished surfaces.
6 Working with the device:
• Never work without dust protection mask and safety
glasses. Some dusts have a hazardous effect! Mate-
rials containing asbestos may not be machined!
• Do not work with damaged tools!
- 14 -
230 V, 50/60 Hz, ~
100 Watt
KB 3 min
approx. 260 mm
approx. 880 gr.
800-2500 rpm
50 mm
< 70 dB(A)
For applying polishing emulsion to paint and metal surfaces and
subsequent polishing. With touch fastener.
Ø 50 x 25 mm.
Made of high-quality, thick lambskin for polishing scratchproof
paints. With touch fastener. Ø 50 mm.
For polishing metals (e.g. stainless steel, brass and copper).
With touch fastener.
Made of silicon carbide. For finishing of paint surfaces, removing
paint drips and inclusions. With touch fastener. Ø 50 mm.
5 Commissioning
Your WP/E angle polisher is delivered ready for use and,
except for the fitting of polishing tools to the rubber
backing disc, no special commissioning measures need
to be taken.
However, please check the device and the polishing tools
for any visible wear before every use!
Always ensure your own safety!
Despite its compact size, the WP/E angle polisher is an
electric tool that harbours a certain level of risk. Always
ensure that the mains plug is disconnected when check-
ing the device, during cleaning or when changing pol-
ishing tools!
5.1 Rubber backing disc with quick-action touch
fastener (Fig. 2)
Polishing tools 1 (e.g. the polishing sponge or felt disc)
are fixed to the rubber backing disc 3 with the touch fas-
tener 2. Rapid and safe changing of polishing tools
therefore poses no problem when adjusting to different
materials or machining stages. When changing a pol-
ishing tool, simply pull of the tool and press on the
replacement!
• Ensure the work piece is fixed securely! Loose work
pieces should be clamped in a suitable fixture. This
prevents the work pieces from flying about.
• A correct and uniform speed achieves a high perfor-
mance, not excessive contact pressure! Excessive
pressure is to be avoided: it only stresses the device
Advertenties
