Advertenties
Translation of the Original
GB
Operating Instructions
PROXXON WP/E Angle
Polisher
Dear customer!
Always keep these operating instructions and the
enclosed safety guidelines within reach.
Only use this device with exact knowledge of it and com-
ply with the instructions and safety guidelines!
This is necessary to ensure safe operation and, secondly,
it facilitates familiarisation with the device and its func-
tions.
Proxxon assumes no liability for the safe function of the
device in the case of:
• handling that does not comply with normal intended
use,
• use for other purposes not mentioned in the manual,
• incorrectly executed repairs,
• failure to heed safety instructions,
• external effects for which the manufacturer is not
responsible.
We recommend using PROXXON original spare parts for
all repair and maintenance work.
Repairs should only be performed by qualified skilled
personnel!
Please note: All information contained in these operat-
ing instructions - especially the technical data - corre-
sponds to the status at the time of printing.
We reserve the right to make further developments in
the interest of technical progress. We wish you every
success with the device.
WARNING!
Read all safety warnings and instructions. Fail-
ure to follow all safety warnings and instruc-
tions listed below may result in electric shock, fire and/or
serious injury.
KEEP ALL SAFETY WARNINGS AND INSTRUCTIONS FOR
THE FUTURE !
Safety Warnings Common for Grinding, Sanding,
Wire Brushing, Polishing or Abrasive Cutting-Off
Operations:
a.) This power tool is intended to function as a
sander or polisher. Failure to follow instruc-
tions listed below may result in electric shock,
fire and/or serious injuries.
b.) This electric power tool is not suitable for
grinding, wire brushing and cutting-off oper-
ations. Uses for which the power tool is not
intended can cause hazards and injuries.
c.) Do not use accessories which are not
designed or recommended by the manufac-
turer specifically for this power tool. Just
because the accessory can be attached to your
power tool does not assure safe use.
d.) The rated speed of the bits and cutters must
be at least equal to the maximum speed spec-
ified on the power tool. Accessories that turn
faster than their rated speed can break and fly
apart.
e.) The outside diameter and thickness of the bits
and cutters must be within the capacity rating
of your power tool. Incorrectly sized bits and
cutters cannot be adequately guarded or con-
trolled.
f.) The arbour size of discs, flanges, grinding
discs or other accessories must properly fit
the grinding spindle of your power tool. Bits
and cutters that do not fit the grinding spindle
of the power tool properly will turn unevenly,
vibrate very strongly and cause loss of control.
g.) Do not use damaged bits and cutters. Before
each use, inspect bits and cutters such as
sanding discs for chips and cracks, grinding
discs for cracks, strong wear or tear, wire
brushes for loose or broken wires. If the power
tool or bits and cutters are dropped, check for
damage or install undamaged bits and cut-
ters. After you have inspected and installed
the bits and cutters, keep yourself and any
other persons in the vicinity away from the
plane of the rotating bits and cutters and run
the device at maximum rotational speed for
one minute. Damaged bits and cutters usually
break during this test time.
- 11 -
Advertenties
