Inhoudsopgave
Advertenties
Installation
6.2
Steps for installation
NOTICE!
A
The manufacturer only assumes liability for parts included in the scope
of delivery. The validity of the warranty expires if the device is installed
together with third-party parts.
Check whether the roof of the vehicle is able to support the weight of
a person before climbing onto it. Ask the vehicle manufacturer about
the permitted roof loads.
6.2.1
Removing the sunroof
➤ Remove all screws and fixtures of the existing sunroof.
➤ Take out the sunroof.
➤ Remove the sealant around the opening, so that the surface is clean
and free of grease.
NOTE
I
Dispose of all waste material, glue, silicone and seals separately.
Observe the local disposal guidelines.
6.2.2
Preparing the unit fastening
➤ Enlarge the existing
a diameter of 8.5 mm (fig. 5 5, page 4).
6.2.3
Preparing the unit
NOTICE!
A
During preparatory work on the surfaces, secure the unit from falling
down.
Make sure that the work surface is clean and level to ensure that the unit
is not damaged.
➤ Place the air conditioning roof unit on a work surface with the housing
facing down.
NOTICE!
A
Screw in the thread insert vertically.
Do not exceed the screw torque of
8 Nm for M6
10 Nm for M8
32
All manuals and user guides at all-guides.com
6.5 mm drill holes for fastening the sunroof to
CoolAir RT880
EN
Advertenties
Hoofdstukken
Inhoudsopgave
