Download Inhoudsopgave Inhoud Print deze pagina

Replacing The Backing Pad; Charger Cleaning Instructions - MIRKA AROS-B 150NV Handleiding

Inhoudsopgave

Advertenties

Beschikbare talen
  • NL

Beschikbare talen

  • DUTCH, pagina 149
en
Compliance with the radio regulations in North America has been verified in accordance with FCC Part 15 subpart B
and C, RSS-GEN, RSS-247 and FCC §15 247
Maintenance
Always disconnect the power before maintenance!
Only use original Mirka spare parts!

Replacing the backing pad

1 Hold the spindle with fingers
2 Turn the backing pad counterclockwise to remove it
3 Fit and tighten the new backing pad
Cleaning
Use a soft brush to remove any accumulated dust Wear safety glasses to protect your eyes while cleaning
If the body of the tool needs cleaning, wipe it with a soft damp cloth A mild detergent can be used
WARNING: Never use alcohol, petrol or other cleaning agent Never use caustic agents to clean plastic parts

Charger cleaning instructions

Dirt and grease may be removed from the exterior of the charger using a cloth or soft non metallic brush Do not use
water or any cleaning solutions
Further service
Servicing must always be performed by trained personnel To keep the tool warranty valid and ensure optimal tool
safety and function, servicing must be carried out by a Mirka authorized service center To locate your local Mirka
authorized service center, contact Mirka Customer service or your Mirka dealer
Troubleshooting guide
Symptom
No light from sander right LED when
trigger is pressed.
The right sander LED is red and the
sander slows down to 4 000 rpm or stops
when sanding.
The right sander LED is red and rpm is
slightly reduced.
The left LED is red and the sander is not
running.
56
Mirka® AROS-B 150NV & AOS-B 130NV • 32 mm (1 ¼") • 10.8 V
Possible cause
Battery pack not properly attached to the
sander
Battery totally empty
Temperature too high in the sander Heavy
load for too long
Too heavy short-term load
The battery voltage is too low
Solution
Insert the battery properly
Charge the battery
Reduce the load on the sander for some
time and the sander will speed up again
Use lighter load or wait a moment and the
LED will automatically change to green
Charge the battery

Advertenties

Inhoudsopgave
loading

Deze handleiding is ook geschikt voor:

Aos-b 130nv

Inhoudsopgave