Inhoudsopgave
Advertenties
en | us • ca
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canada's licence-exempt RSS(s) Operation is subject to the following two conditions:
1 This device may not cause interference
2 This device must accept any interference, including interference that may cause undesired operation of the device
Compliance
This device complies with part 15 of the FCC Rules Operation is subject to the following two conditions:
1 This device may not cause harmful interference
2 This device must accept any interference received, including interference that may cause undesired operation
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules These limits are designed to provide reasonable protection against harmful interference in a
residential installation This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications However,
there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
CAUTION TO THE USER: Changes or modification not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment
This device complies with Industry Canada's licence-exempt RSSs Operation is subject to the following two conditions:
1 This device may not cause interference; and
2 This device must accept any interference, including interference that may cause undesired operation of the device
WARNING
• Always wear required personal safety protection in accordance with manufacturer's instructions and local/national
standards while using this tool
• Read the Materials Safety Data Sheet (MSDS) for the work surface
• If any physical hand/wrist discomfort is experienced, stop working and seek medical attention Hand, wrist and arm
injury may result from repetitive work, motion and overexposure to vibrations
Safety rules for battery pack and charger
WARNING!
• Important safety and operating instructions for your battery and charger Before using the charger, read all
instructions and warnings on the charger, the battery pack and the tool
• If the battery pack casing is cracked or damaged, do not insert into charger There is a danger of electric shock or
electrocution
• Do not allow any liquid to get inside charger Electric shock may result
• This charger is not intended for any uses other than charging rechargeable batteries
• Do not place any object on top of the charger, near any heat source or place the charger on a soft surface that may
result in excessive internal heat
228
Mirka® AROS-B 150NV & AOS-B 130NV • 32 mm (1 ¼") • 10.8 V
CONFORMS TO UL STD
62841-1, 62841-2-4
CERTIFIED TO CSA STD
C22 2 No 62841-1, C22 2 No 62841-2-4
Advertenties
Inhoudsopgave
