Inhoudsopgave
Advertenties
Charging procedure
• Connect the power cord to the charger, and then plug into an outlet before inserting battery pack All three charging
lights will be on for two seconds and then turn off
• Insert the battery pack into the charger The lights will start to flash within 30 seconds
• During the charging process, the charging lights will indicate the status as follows:
– Three charging lights will flash in sequence during the charging process
– Fully charged, all three lights will remain on continuously
• The charging process will last approximately 40 minutes for Mirka 10 8 V 2 0 Ah battery pack
NOTE: This charger can only charge Mirka 10 8 V battery packs
NOTE: Charging times may be longer depending on the surrounding temperature and battery conditions
LED indication of 10.8 V charger
LED
3
2
1
Pre-charge
(Trickle charge)
Remain continuously on
Charger diagnostics
The charger will indicate if:
• A battery pack is overheated All three charging lights will flash Remove the battery and allow it to cool down for
15–30 minutes and re-insert
• A malfunction occurs in the battery or the charger Two charging lights will flash Remove the battery and allow it to
cool down Re-insert the battery pack into the charger If two charging lights still flash, the battery or charger may
require service
How to get started
• When unpacking the tool, make sure it is intact, complete and has not been damaged in transport Never use a
damaged tool
• Before use, check that the backing pad is correctly mounted
• Install the fully charged battery pack into the sander until it locks in place with a click
Operating instructions
• The tool is intended to be operated as a hand-held tool The tool can be used in any position
• Select a suitable abrasive and secure it to the backing pad Make sure the abrasive is centered on the backing pad
• The sander can now be activated / turned on and started by pressing the switch trigger
• The sander will run and stay in active mode as long as the trigger is pressed After the trigger is released the sander
will stop but continue to stay in active mode for a short time before it automatically deactivates / turns off
• When sander is in active mode the right LED is green
• In active mode the left LED shows the battery status:
– Green: Battery charge level is OK
– Flashing green/red: Battery charge level is weak
– Red: Battery voltage too low Sander is not operable
Charging...
Charging...
Flashing
Charging finished
Over temperature
Mirka® AROS-B 150NV & AOS-B 130NV • 32 mm (1 ¼") • 10.8 V
en | us • ca
Battery failure
231
Advertenties
Inhoudsopgave
