Inhoudsopgave
Advertenties
All manuals and user guides at all-guides.com
8.16
Installing / replacing the cutting blade (Fig. 5A-F)
Unhook the guard extension from the cutting attachment guard.
CAUTION! Ensure that the guard extension is removed.
Fit the top clamping plate on the output shaft.
Turn the blade shaft until one of the holes in the top clamping plate aligns with the
corresponding hole in the top cutting attachment guard.
Insert the locking pin in the hole to lock the shaft.
Place the blade, bottom clamping plate and bottom cutting attachment guard on the output
shaft.
Fit the nut. The nut must be tightened to a torque of 35-50 Nm. Use the socket spanner in
the tool kit. Hold the shaft of the spanner as close to the blade guard as possible. To
tighten the nut, turn the spanner in the opposite direction to the direction of rotation
(Caution! left-hand thread).
Pull out the locking pin after all installation process has been finished.
8.17
Installing / replacing the trimmer head & trimmer guard (Fig. 6A-C)
Hook the trimmer guard onto the cutting attachment guard.
Fit the top clamping plate on the output shaft.
Turn the blade shaft until one of the holes in the top clamping plate aligns with the
corresponding hole in the top cutting attachment guard.
Insert the locking pin in the hole to lock the shaft.
Screw on the trimmer head in the opposite direction to the direction of rotation.
To dismantle, follow the instructions in the reverse order.
8.18
Putting on the carrying harness (Fig. 7)
Note: the following adjustments can be made to make sure that you can work
without becoming fatigued. The settings may vary depending on your body
size.
Before starting to work, adjust the carrying harness to suit your body size.
Balance the appliance with the fitted cutting tool so that the cutting tool
swings just over the ground without the need to move the appliance with
your hands.
Put on the carrying harness and close the claps so that they can click into place (Fig. 7a).
Pull on the belt, to position the carrying harness centrally on your body and adjust the
upper body size (Fig. 7B).
To tight the two shoulder straps, pull on the two shoulder straps (Fig. 7C).
To ensure to the correct position of the appliance on the carrying harness, pull the belt (fig.
7D)
Hook in the carabiner (Fig. 7E-G) and secure it with the red strap on the quick release
mechanism
Now take the appliance and hang it so that the carrying lug (3) clicks into the carabiner.
(Fig. 7H) The carrying lug (3) can also be moved by loosening the screw and sliding it to
achieve the optimum orientation of the appliance.
P a g e
| 16
EN
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
