Inhoudsopgave
Advertenties
All manuals and user guides at all-guides.com
8.4
Attaching the round handle (Fig. 2)
Start by fitting the rubber ring (5a) on the shaft (8).
Attach the barrier bar (6) onto the rubber ring (5a) from below.
The pin (5b) of the barrier bar (6) must be pushed into one of the two holes of the shaft (8)
to lock into place.
Push the round handle (5) onto the rubber ring (5a) provided on the shaft (8).
Insert the 4 mounting bolts (4) from above through the round handle (5) and fix them onto
the barrier bar (6) with the 4 nuts.
Tighten the screws.
8.5
Quick release (Fig. 3)
There is an easily accessible, quick release fitted near the suspension ring as a safety
precaution in case the engine catches fire, or in any other situation that requires you to free
yourself from the machine.
8.6
Adjusting the harness
WARNING! When using the machine it must always be hooked securely to
the harness. Otherwise you will be unable to control the brush cutter safely
and this can result in injury to yourself or others. Never use a harness with a
defective quick release.
Put on the harness. Hook the machine onto the harness support hook. Adjust the length of the
harness so that the support hook is roughly level with your right hip.
8.7
Assembling the hedge trimmer (Fig. 4)
Start by undoing the screw grip (7) on the shaft (8) of the engine unit.
Push the pin on the front shaft (23) on the hedge trimmer into the groove on the engine
unit shaft (8) as far as the stop. Once it is correctly inserted, the red line must match up
with the one on the engine unit shaft.
Tighten the screw grip (7).
Note: assembly of chain saw / trimmer / brush cutter / extension attachment
is carried out in the same order
8.8
Removing the hedge trimmer
Undo the screw grip (7) and pull the front shaft (23) of the hedge trimmer out of the engine unit
shaft (8).
Note: removal of chain saw / trimmer / brush cutter / extension attachment is
carried out in the same order
P a g e
| 13
EN
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
