Inhoudsopgave
Advertenties
TROUBLESHOOTING
Faults table
When you have any doubts about whether your appliance is working properly you should not
immediately assume that it is defective. We recommend that you should in any case check the
points in the following table.
Problem
Appliance is connected to the
power mains but it does not
work.
Cooling system operates
continuously for a long period
of time.
Excessive ice formation in the
freezer.
The door does not open
easily.
Cause or remedy
• Make sure there is voltage in the power outlet and that the
appliance is switched on.
• The ambient temperature is too high.
• The door has been opened for too long or too frequently.
• The door is not closed properly.
• The door does not seal properly (the seal is dirty, the door
is misaligned or the seal is damaged, etc.).
• Too much fresh food has been put in at the same time.
• Insufficient air circulation around the compressor and
condenser. Check that the ventilation around the appliance
is sufficient (see the separate installation instructions).
• Freezer compartment is not periodically defrosted. Defrost
the freezer compartment to remove the ice.
• Door opened too frequently or too long.
• Door not properly closed.
• The door does not seal properly. If the seal is dirty or
damaged, clean or replace it.
• You are trying to open the appliance's door just after
you have closed the door. Then opening the door is
difficult. When you open the door, cold air escapes
from the appliance and is replaced by warm air from the
surroundings. As this air cools a slight vacuum is created
that makes it more difficult to open the door. The situation
returns to normal after a few minutes, and the door opens
easily again.
EN 23
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
