Inhoudsopgave
Advertenties
All manuals and user guides at all-guides.com
6. OPERATION
WARNING: Before any work on the machine (e. g. maintenance, changing the tool, etc.) as
well as during its transport and storage, Safety lock-off in the off position. There is danger of
injury when the On/Off switch is unintentionally actuated.
To close the blade 1(Fig. 1) activate the safety lock-off (Fig. 1 / Item 4) by pushing it forward and
pressing the ON/ OFF switch (Fig. 1 /Item 3) at the same time. To open the blade 1, let go of the
ON/OFF switch (Fig. 1 / Item 3).
Never operate the machine in an awkward posture. This may cause serious injury.
Keep your free hand away from the cutting area. Never touch the blades. They are very sharp
and you may cut yourself. Always wear protective gloves while pruning.
6.1 Changing the blade (Fig. 5a-5c)
Warning! Remove battery from pruner before Changing the blade.
Always wear protective gloves when Changing the blade.
Never attempt to operate the machine without the blade, spacer or screw correctly secured
to prevent damage to the machine.
To remove the blade 1, Use a Hexagon wrench socket key (not provided) to remove the blade nut
19 which secures the blade. Remove the blade wave washer 18 and the washer 17 then remove
the blade screw 20(Fig.5a). Remove the blade 1 along 45 ° direction (Fig. 5b).
To Insert the blade 1, Be careful not to allow any foreign matter to become attached to the
blade gear and do not damage it. First Insert part of the tooth of the blade 1 into the case as
shown(Fig.5c), then rotate the blade 1 until the hole of the blade 1 is aligned to the hole of the
aluminum gearbox. Incorrect location of the blade will damage the machine. Refit the blade
screw 20 then refit the washer 17 and the wave washer 18, at last tighten the blade nut 19. Do not
over tighten.
7. CONNECTING THE POLE (FIG. 6A-6B)
Using the telescopic long handle (Fig. 1) You can prune the branches farther away .
Holding The Connecting pole with one hand, and the front of the pruner with the other, first push the
battery pack on the pruner in to The pruner bracket(Fig. 1a/Item 6) as shown(Fig. 6a), Until the
pruner is fully in place. Close The pruner cover (Fig. 1a/Item 5) and tighten the butterfly bolt(Fig.
6b/Item 21). Then connect the power connector (Fig. 1a/Item 7) to the battery pack on the pruner.
To take apart, proceed in the reverse order.
45
Advertenties
Inhoudsopgave
