Inhoudsopgave
Advertenties
• Try to keep the impact from vibrations as low as possible. Exposure to vibrations can be reduced
by wearing gloves when using the tool, for example, and by limiting the amount of operating time.
This includes the full cycle of operation (e.g. times when the power tool is switched off and times
when the tool is switched on but no working load is applied).
5. BEFORE STARTING THE EQUIPMENT
5.1 Installing the battery (Fig. 3a/3b)
Press the both side of the battery pack as shown in Fig. 3a and push the battery pack into the mount
provided. When the battery pack is positioned as in Fig. 3b, make sure that the battery pack latch in
place! To remove the battery pack, proceed in reverse order.
5.2 Charging the battery (Fig. 4)
1. Take the battery pack out of the equipment. Do this by pressing the both side of the battery pack.
2. Check that your mains voltage is the same as that marked on the charger rating plate . Connect
the power plug of the charging unit to a socket outlet, then insert the charging unit to battery pack .
The red LED was always light .
3. The charging unit will end the charging automatically when the battery is fully charged (after
approx. 3~5 hours). The green LED then lights up and the red LED light out.
The battery pack can become a little warm during the charging. This is normal. If the battery pack
fails to charge, the green and red LED in the battery light up. check:
• whether there is voltage at the socket outlet
• whether there is good contact at the charging contacts
If the battery pack still fails to charge, send
• the Battery charger
• and the battery pack to our customer service center.
To ensure that the battery pack provides long service, you should take care to recharge it promptly.
You must recharge the battery pack when you notice that the power of the cordless pruner drops.
Never fully discharge the battery pack. This will cause it to develop a defect.
All manuals and user guides at all-guides.com
44
Advertenties
Inhoudsopgave
