Inhoudsopgave
Advertenties
▶ Do not crimp live parts. The tool must be considered to be uninsulated and must therefore be used
in conjunction with personal protective equipment (protective gloves, protective footwear, protective
clothing, etc.) of a type suitable to provide protection for yourself and other persons in the vicinity.
Power tool use and care
▶ After approx. 50 consecutive crimping operations, switch the power tool off and allow it to cool down for
about 15 minutes. Overheating can lead to damage to the power tool.
2.3
Careful handling and use of batteries
▶ Observe the special guidelines applicable to the transport, storage and use of lithium-ion batteries.
▶ Do not expose batteries to high temperatures, direct sunlight or fire.
▶ Do not disassemble, crush or incinerate batteries and do not subject them to temperatures over 80 °C
(176 °F).
▶ Do not use or charge batteries that have suffered mechanical impact, have been dropped from a height
or show signs of damage. In this case, always contact your Hilti Service.
▶ If the battery is too hot to touch it may be defective. Put the battery in a place where it is clearly visible
and where there is no risk of fire, at an adequate distance from flammable materials. Allow the battery to
cool down. If it is still too hot to touch after an hour, the battery is faulty. Contact Hilti Service.
3
Description
3.1
Product overview
3.2
Intended use
The product described is a cordless electro-hydraulic crimping tool.
It is designed for crimping fittings used to connect composite, copper (Cu) and steel pipes.
•
Use only Hilti lithiumion batteries of the B 22 series with this product.
•
Use only Hilti-approved battery chargers to charge these batteries. More information is available from
your Hilti Store or from www.hilti.group
3.3
Possible misuse
•
Do not use this hand-held product clamped in a fixed position or as a stationary device.
•
This electro-hydraulic crimping tool may not be exposed to heavy rain or used under water.
3.4
Lithiumion battery status display
The charge state of the Li-ion battery and malfunctions of the product are indicated by the indicator of the
Liion battery. The state of charge of the Liion battery is displayed after pressing one of the two battery
release buttons.
*2188465*
1
2188465
Crimping / pressing head
@
Piston return switch to open the crimping /
;
pressing jaws in the event of a fault or emer-
gency
Casing
=
Servicing and fault indicator (red LED)
%
Battery release button
&
Battery
(
Slot on both sides to fasten the Hilti retaining
)
leash
White LED to illuminate the working area
+
Control switch
§
Locking pin for opening/closing the tool head
/
Crimping / pressing jaws
:
Pressing ring with adapter jaws
∙
English
17
Advertenties
Inhoudsopgave
