Inhoudsopgave
Advertenties
Jet 8 iPlus
E14
Motor stall protection
E15
Lift sensor failure
E16
Motor cannot start
E17
Motor overcurrent
protection
E18
Over temperature
E19
Stall
3. Contact after-sales service to replace the motor.
1. Turn off the power and wait for 3 minutes, then turn on the
power again to see if it returns to normal.
2. After the power is turned off, use your feet to push the
running belt to see if it takes a lot of force. If so, please
maintain the running belt and add lubricating oil or adjust the
tightness of the running belt until it can be easily pushed and
then use it after the power is turned on.
3. Contact after-sales service to replace the controller.
4. Contact after-sales service to replace the motor.
1. Check the connection line of the lift sensor and reconnect
it.
2. Contact after-sales service to replace the lifting motor.
3. Contact after-sales service to replace the controller.
1. Turn off the power and wait for 3 minutes, then turn on the
power again to see if it returns to normal.
2. Contact after-sales service to replace the controller.
3. Contact after-sales service to replace the motor.
1. Turn off the power and wait for 3 minutes, then turn on the
power again to see if it returns to normal.
2. After the power is turned off, use your feet to push the
running belt to see if it takes a lot of force. If so, please
maintain the running belt and add lubricating oil or adjust the
tightness of the running belt until it can be easily pushed and
then use it after the power is turned on.
3. Contact after-sales service to replace the controller.
4. Contact after-sales service to replace the motor.
1. Turn off the power and wait for 30 minutes, then turn on
the power again to see if it returns to normal.
2. Check whether the motor cover is blocked and remove the
obstruction before use.
3. Contact after-sales service to replace the controller.
4. Contact after-sales service to replace the motor.
1. Turn off the power and wait for 3 minutes, then turn on the
power again to see if it returns to normal.
2. After the power is turned off, use your feet to push the
running belt to see if it takes a lot of force. If so, please
maintain the running belt and add lubricating oil or adjust the
tightness of the running belt until it can be easily pushed and
then use it after the power is turned on.
3. Contact after-sales service to replace the controller.
4. Contact after-sales service to replace the motor.
Manual – Treadmill – Focus Fitness Jet 8 iPlus
26
Advertenties
Inhoudsopgave
