Inhoudsopgave
Advertenties
Jet 8 iPlus
The speed window will display PLUG KEY prompting the user to insert the safety lock.
4. Motion parameter display and setting range
SPEED (KM/H)
TIME (MIN)
DISTANCE(KM)
CALORIE（CAL）
Ascension
5. Fault information and handling
Error Code Fault Meaning
E0
Safety switch falls off
E01
Communication Error
E02
Overcurrent
protection
E03
Overload
E08
Speed (Hall) signal
lost
E11
Undervoltage
protection
E12
Overvoltage
protection
E13
Motor phase loss
protection
Display Range
Program default
1.0~18
0:00~99.59
30：00
0~99.9
0-999
0-12
Simple Solution
1. Check whether the safety switch is properly placed and
check the connecting wires.
2. Contact after-sales service to replace the safety switch or
wire.
3. Contact after-sales service to replace the electronic watch
mainboard.
4. Contact after-sales service to replace the controller.
1. Reconnect the communication cable to see if it can be
restored.
2. Contact after-sales service to replace the communication
cable.
3. Contact after-sales service to replace the electronic watch
mainboard.
4. Contact after-sales service to replace the controller.
1. Turn off the power and wait for 3 minutes, then turn on the
power again to see if it returns to normal.
2. After the power is turned off, use your feet to push the
running belt to see if it takes a lot of force. If so, please
maintain the running belt and add lubricating oil or adjust the
tightness of the running belt until it can be easily pushed and
then use it after the power is turned on.
3. Contact after-sales service to replace the controller.
4. Contact after-sales service to replace the motor.
1. Turn off the power and wait for 3 minutes, then turn on the
power again to see if it returns to normal.
2. After the power is turned off, use your feet to push the
running belt to see if it takes a lot of force. If so, please
maintain the running belt and add lubricating oil or adjust the
tightness of the running belt until it can be easily pushed and
then use it after the power is turned on.
3. Contact after-sales service to replace the controller.
4. Contact after-sales service to replace the motor.
1. Check the speed sensor cable and reconnect it.
2. Contact after-sales service to replace the Hall speed
sensor.
3. Contact after-sales service to replace the controller.
1. Check whether the power supply voltage is normal.
2. Contact after-sales service to replace the controller.
1. Check whether the power supply voltage is normal.
2. Contact after-sales service to replace the controller.
1. Check the motor cable and reconnect it.
2. Contact after-sales service to replace the controller.
Manual – Treadmill – Focus Fitness Jet 8 iPlus
Mode default
┈
┈
30：00
┈
1.0
┈
50
┈
┈
Setting range
┈
1:00~99:00
1.0~99.0
10-990
0-12
25
Advertenties
Inhoudsopgave
