Inhoudsopgave
Advertenties
Transmitter installation
The transmitter is secured to the back of the changeover
system. Hold the transmitter as shown in Figure 3 and push
it into the changeover system support from the side until it
engages tangibly.
Figure 3
Lead the transmitter's connector cable out of the cylinder box
and connect it to the plug on the control panel cable.
Cable colours on the transmitter plug:
Cable colours on the control panel plug: pink, yellow, brown
10
EN
EisEx installation
Check the locating hole on the gas pressure regulator or
changeover system for soiling, and clean it if necessary. Insert
the heating cartridge into the locating hole and secure it with
the supplied screw (Torx 10).
On the changeover system DuoControl (CS), the heating car-
tridge can be inserted and secured from the left or right sides.
On the gas pressure regulator MonoControl (CS), this can only
be done from the right side.
Lead the 2-pole connector cable out of the cylinder box and
connect it to the plug on the control panel cable.
Cable colours on the heating cartridge plug: white, green
Cable colours on the control panel plug:
pink, yellow, brown
Figure 4
Due to the danger of burn injury, do not operate EisEx
in the uninstalled condition!
white, green, grey
Advertenties
Hoofdstukken
Inhoudsopgave
