Inhoudsopgave
Advertenties
Charging parameters that can be set:
Charge for 12V batteries, 2Ah to 40Ah
Maintenance charge for 12V batteries, 2Ah to 100Ah
Suitable for charging Pb: WET – GEL – AGM batteries
Charge for 12V batteries, 2Ah to 40Ah
Maintenance charge for 12V batteries, 2Ah to 100Ah
Suitable for charging lithium batteries: LiFePO4 (do not charge other types of lithium batteries)
Charge indicators:
The battery is charging.
The battery is charging.
The battery is fully charged (100%); the battery charger will switch to the maintenance step, keeping
the state of efficiency of the battery constantly monitored, so that it is always at an optimal level of
charge.
INTERRUPTION OF THE CHARGE CYCLE IN CASE OF MAINS BLACKOUT
In case of blackouts in the 230V mains, the battery charger saves the work cycle it was performing in order to restore
it automatically as soon as the power supply of the 230V mains is restored. This function is crucially important if the
battery charger is used to charge batteries without the operator supervising the cycle; for example, during very long
work cycles (maintenance charges) or when charging overnight (charges for vehicles that need to be charged daily).
(The set parameters are stored for 12 hours; after 12 hours the battery charger will resume charging with the default
parameters).
END-OF-CHARGING
1. Unplug the power supply lead of the battery charger from the mains.
2. Disconnect the output lead with black clamp from either the vehicle's earthing point or the negative terminal (-) of
the battery.
3. Disconnect the output lead with red clamp from the positive terminal (+) of the battery.
BATTERY TESTS AND ERROR INDICATORS
In cause of faults, the battery tester will display the following indications:
DISPLAY INDICATION CAUSE
The clamps of the output leads are not
connected correctly to the battery.
Polarity reversal.
Battery
voltage
too
attempting to charge a 24V battery).
Battery capacity excessive.
Battery cannot maintain a good level of
charge.
Battery flat.
SOLUTION
Position the clamps correctly and start
charging the battery again (see section
"Operating the battery charger").
high.
(You
are
Check the battery voltage.
Use battery charger with greater charging
capacity.
The battery may be defective. Contact your
nearest battery service centre.
Press the button again, to restart charging,
and try to recover the battery.
Advertenties
Inhoudsopgave
