Inhoudsopgave
Advertenties
5. LOADING THE MEDIA
5. Put the media on the supply shaft.
6. Pass the media around the damper, then pull the media towards the front of the printer. Fix the remaining
supply holder to the supply shaft with the pinchers facing away from the printer.
7. Insert the media into the paper holders of the media guide, adjust the media guides to the media width,
and tighten the locking screw.
8. Check that the media path through the printer is straight. The media should be centered under the print
head.
Media Guide
Locking Screw
NOTE: When using the label rolled with labels facing outside, please remove the upper plates of both
paper holders using the following procedure. Failure to do this may cause a paper jam error.
If you have any questions, please contact your nearest TOSHIBA TEC service representative.
All manuals and user guides at all-guides.com
Damper
Media
Paper Holder
E5-2
ENGLISH VERSION EO1-33007
5. LOADING THE MEDIA
Media
Supply Holder
(FMHD0005502)
Supply Shaft
Supply Holder
Media Guide
Paper Holder
Print Head
Media
Fig. 5-3
Fig. 5-4
Advertenties
Hoofdstukken
Inhoudsopgave
