Download Inhoudsopgave Inhoud Print deze pagina

Mark Infra ER+ 2500W Technische Handleiding pagina 5

Inhoudsopgave

Advertenties

2.0 Product data
The MARK Infra ER+ produce instant and comfortable heat like the sun. These robust and
weatherproof heaters are designed for domestic and commercial heating applications within
indoor and outdoor areas.
MARK Infra ER+ 2500W
Voltage (V)
Wattage (W)
Hertz (Hz)
Dimensions WxHxD (mm)
Weight (kg)
3.0 Installation
Tools Needed:
Pencil
Hammer
Level
Screw Driver
Power Drill and drill bits
A Wall/ceiling mount swivel bracket is provided with the heater which has been specifically
designed to allow this product to be fitted to a wall or ceiling. Before drilling, make sure that the
wall/ceiling is solid and that there are no hidden water pipes or electric wires.The heater must be
installed no less than 19.7" (0.5m) from side walls and no less than 2.4m off the floor.
ATTENTION! The appliance must be installed on the solid surfaces like concrete, wood or metal
etc.
Important: Ensure that the supply cables is well mounted and that it does not come into contact
with reflector of the heater or that does not trail into heated area, the supply cable can be fixed
to the metal mounting bracket behind heater with plastic zip ties.
1.
This heater should be installed by a competent person, i.e. a qualified electrician.
2.
Always disconnected the heater from the electricity supply and allow it to cool before
installation.
3.
For ceiling mounting, the lowest part of the heater must be located at or above a minimum
height of 3m from ground level, so that the heater can not be touched when in operation.
4.
When installed to the ceiling, there must be a distance of 0.5m between corners and the
appliance.
5.
The distance of your appliance from living beings is to be minimal 1m.
6.
The distance from the front side of the heater to materials such as wood, carton, cloth etc.,
must be minimal 1m.
7.
When mounting to a ceiling, do not position the heater at an angle of more than 90° and less
than 45°.
8.
The supply cable must be at the lower end of the heater if the heater is installed at an angle
or vertically.
220-240 V AC
2500
50/60
900×130×89.5
3.0
EN
5 5

Advertenties

Inhoudsopgave
loading

Inhoudsopgave