Inhoudsopgave
Advertenties
6. OPERATING INSTRUCTIONS
Before using the device make sure that you have
read the operating instructions for the battery
and the vehicle and you have understood all of
the safety precautions.
6.1 OVERVIEW
Figure 1: View of front
1 Carry handle
2 Switch for selecting charging mode normal/fast
3 Switch for selecting battery type normal/gel
4 Control lamp – Green - Fully charged
5 Control lamp – Yellow - Charging
6 Control lamp – Green - Operating
7 Control lamp – Red - Pole callipers connected incorrectly
Figure 2: View of rear
1 Carry handle
8 Mounts for cable holder
9 Type plate
10 Mains connection cable
11 Charging cable
6.2 INSERTING THE CABLE HOLDER
Insert the cable holder into the mounts (Position 8 in the over-
view) on the rear of the charger so that the openings of the
vertically aligned cable holders face away from each other.
6.3 PREPARATION
Clean the battery poles to remove dust and corrosion residue.
Only for open batteries: Remove the plugs of the bat-
tery cells. Check the liquid level in the cells, consult the
operating instructions of your battery for more information.
Replenish only sufficient distilled water to ensure that the
minimum filling level is achieved. The liquid will expand
during the charging process and the battery may overflow.
Leave the cells of the battery open until the end of the
charging process.
In case of closed and maintenance-free batteries, please fol-
low the instructions of the battery manufacturer to the letter.
6.4 CONNECTING THE BATTERY CHARGER
CAUTION
Make sure that the charger is not connected to
the power socket.
Make sure that the charger is not connected to the power
socket. Always connect the red positive cable (+) of the
charger (Position 11 in the overview) to the positive pole of
the battery first. Then connect the black minus
cable (-) to the minus pole of the battery. If you charge the
battery in situ, connect the black negative cable (-) to the
car body (exposed part), far away from the battery, the
carburettor and fuel lines. Always maintain this sequence.
CAUTION
When the red control lamp (Position 7 in the
overview) lights up, the charging cables have
been connected incorrectly. Remove the pole
callipers from the battery poles and connect
them correctly.
6.5 CHARGING THE BATTERY
6.5.1 SELECTING THE BATTERY TYPE
If a standard lead acid battery, a maintenance-free battery
or an AGM battery is to be charged, set the switch for the
battery type (Position 3 in the overview) to the „NORMAL"
position. For gel batteries, set the switch to „GEL".
9
Advertenties
Hoofdstukken
Inhoudsopgave
