Advertenties
Initial operation and general information
The induction milk frother is intended for heating and frothing milk and milk substitutes. In general,
the following milk types can be used:
fresh milk, UHT milk (including from cows, sheep and goats) and lactose-free milk as well as milk
substitutes (such as soya milk) with various fat contents.
The quality and volume of the milk foam depends on the type and characteristics of the milk being
used (e.g. the fat and protein content, temperature, etc.).
Prior to initial use, clean the device as described in the section entitled „Cleaning and care." Any sur-
plus length of the connecting cable can be wound around the bottom of the device's base (6). Connect
the mains plug to an earthed wall socket.
The WMF LONO Milk&Choc has four programmes:
Symbol Programme
Application
This thick milk foam is
perfect for use with cap-
Hot milk foam
puccino or latte macchiato
drinks.
This cold, creamy milk foam
is especially well suited for
Cold milk foam
frappé drinks, cocktails, iced
coffee and desserts.
This programme provides a
quick and easy way to heat
Hot milk
milk, e.g. for latte coffees
or cups of warm milk.
Use this programme to
Hot chocolate
make hot chocolate drinks
using crumbled chocolate.
14
DISC
Filling volume
WMF Milk System
MIN 150 ml
MAX 350 ml
MIN 150 ml
MAX 350 ml
MIN 150 ml
MAX 500 ml
WMF Choc System
milk
MIN 150 ml
MAX 350 ml
chocolate
MAX 34 g
Preparing milk foam and hot milk:
Note: Use the WMF Milk System for this programme. (Fig. A)
▪ Hold the WMF Milk System (3) by its handle and stand it vertically within the jug. A magnet then
holds the WMF Milk System (3) to the fl oor of the jug.
▪ Fill the jug (5) with chilled milk, observing the MIN and MAX level indicators (see chart). Do not
exceed the indicated maximum, otherwise milk may slosh out during preparation.
▪ Stand the jug (5) on the device base (6).
▪ Place the lid (1) on the jug (5) and apply slight pressure to ensure that it seals. Ensure that the end
of the handle of the WMF Milk System (3) is positioned within the lid mechanism.
▪ Now press the on/off button (7) repeatedly until the LED next to the symbol
desired programme lights up.
▪ Approx. 3 seconds later, the preparation begins automatically. The process may be interrupted at
any time by pressing the on/off button (7) again.
▪ Once the programme has fi nished, the device switches off automatically and the programme light
go out. The on/off button (7) lights up in red.
Note: the device's fans may continue to run beyond the end of the programme.
▪ The jug (5) can now be removed from the base (6). To pour out the contents, remove the lid (1) and
take out the WMF Milk System (3).
Caution: the jug and handle of the WMF Milk System may be hot!
Preparing hot chocolate:
Note: Use the WMF Choc System for this programme. (Fig B)
▪ Hold the WMF Milk System (3) by its handle and stand it vertically within the jug. A magnet then
holds the WMF Milk System (3) to the fl oor of the jug.
▪ Fill the jug (5) with chilled milk, observing the MIN and MAX level indicators (see chart). Do not
exceed the indicated maximum, otherwise milk may slosh out during preparation.
▪ Stand the jug (5) on the device base (6).
▪ Add crumbled chocolate to the milk. For optimal results, we recommend breaking the chocolate
into small chunks. Alternatively, you can use ground or powdered chocolate.
▪ Place the lid (1) on the jug (5) and apply slight pressure to ensure that it seals. Ensure that the end
of the handle of the WMF Choc System (4) is positioned within the lid mechanism.
▪ Press the on/off button (7) repeatedly until the LED next to the „Hot Chocolate" symbol
up.
▪ Approx. 3 seconds later, the preparation begins automatically. The process may be interrupted at
any time by pressing the on/off button (7) again.
▪ Once the programme has fi nished, the device switches off automatically and the programme light
go out. The on/off button (7) lights up in red.
Note: the device's fans may continue to run beyond the end of the programme.
▪ The jug (5) can now be removed from the base (6). To pour out the contents, remove the lid (1) and
take out the WMF Choc System (4).
Caution: the jug and handle of the WMF Choc System (4) may be hot!
Warning: Always place the lid (1) on the device before switching it on. Never remove the lid (1) while
the device is running.
Note: Allow the device to cool down before reuse.
Clean the device and the WMF Milk&Choc System after each use.
of the
lights
15
Advertenties
