Inhoudsopgave
Advertenties
3 Installation
3.3
Bone Conductive Sensor
The bone conductive sensor could be placed inside the front padding of the headband or inside the leather pocket
hooked to the straps of the suspension system.
3.3.1
Installation in the Front Padding
1.
Open the front padding as shown by
detaching the Velcro fasteners.
2.
Slide the bone conductive sensor inside
one of the two pockets as shown.
3.3.2
Installation in the Suspension System
1.
Install the bone conductive sensor in the
leather pocket.
2.
Turn back the pocket on the straps of the
suspension system and keep the leather
strip open.
3.
Pass the leather pocket strip under the
suspension straps. Close with the Velcro
fastener.
6
3.
Ensure the microphone sensor is
positioned towards the face.
The sensor must touch the
forehead while wearing the
helmet.
4.
Place the cable between headband and
headband padding in a way to avoid any
pressure points on the forehead.
5.
Fold back and close the headband by
attaching the Velcro fasteners.
GB
Advertenties
Inhoudsopgave
