Inhoudsopgave
Advertenties
DMX connector configuration
Termination reduces signal errors. To
avoid signal transmission problems and interference, it is always advisable to connect a DMX signal terminator.
Setting up a DMX Serial Data Link
1. Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin connector of the controller.
2. Connect the end of the cable coming from the controller which will have a (female) 3 pin connector to the input
connector of the next fixture consisting of a (male) 3 pin connector.
3. Then, proceed to connect from the output as stated above to the input of the following fixture and so on.
FUNCTION MENU
ADDR A001-A512 001 - 512, DMX Address setting
16CH 24CH
48CH
CHND
select the channel mode
MAST
Master AUTO mode
Soun
Master Sound control mode
SLND
SL1
DMX control mode
SL2
Slave mode
SH0
Effect 0 (recommend)
SH1
Effect 1
SHND
SH2
Effect 2
SH3
Effect 3
SENS
0-99
Sound sensitivity control (0 close, 100 The most sensitive)
bLAc Auto
OFF if no DMX signal is present
Soun
Auto running if no DMX signal is present
bLnd
HoLd
Sound control if no DMX signal is present
Keeps last DMX control state if no DMX signal is present
Red
0-255 White balance adjust 0-255
Green
White balance adjust
Wile
Blue
0-255 White balance adjust 0-255
White balance adjust
White
No
X motor forward moving
rPAN
YES
X motor reverse moving
No
Y3 motor forward moving
rTiL
YES
Y3 motor reverse moving
REST
YES
Reset
Function Mode
DMX address setting
1. Press the the MENU button until "ADDR" is displayed, press ENTER.
COMMON
DMX +
INPUT
DMX -
Resistance 120 ohm
1/ 4w between pin 2
(DMX-) and pin 3
(DMX+) of the last
fixture.
Page 4
Advertenties
Inhoudsopgave
