Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Fault
A warning signal sounds.
The 6 alarm button lights up.
The temperature in the
freezer section is too warm.
The light does not function.
Controls have reduced
luminosity.
Displays do not illuminate.
Appliance is not cooling,
temperature display and light
are lit.
Automatic super freezing
does not switch on.
Possible cause
Fault - the freezer section is
too warm!
Appliance is open.
Ventilation openings are
covered up.
Too much food was placed in
the freezer at once.
Appliance opened
frequently.
The ventilation openings
have been covered.
Large quantities of fresh
food are being frozen.
The LED light is defective.
Appliance was open too
long.
Light is switched off after
approx. 10 min.
When the appliance is not
used for some time,
the display on the fascia
switches to energy saving
mode.
Power failure; the fuse has
been switched off; the mains
plug has not been inserted
properly.
Showroom mode is switched
on.
Remedial action
To switch off the warning signal, press 6 alarm
button.
Close the appliance.
Ensure that there is adequate ventilation.
Do not exceed the freezing capacity.
When the fault has been eliminated, the alarm
button goes out shortly afterwards.
Do not open the appliance unnecessarily.
Remove obstructions.
Do not exceed the freezing capacity.
See chapter "Light (LED)" section.
When the appliance is closed and opened,
the light is on again.
As soon as the appliance is again used, e.g.
the door is opened, the display switches back
to normal illumination.
Connect mains plug. Check whether the power
is on, check the fuses.
Press the temperature selection button,
Fig. "/2, for 5 seconds until a confirmation
signal sounds.
Switch the appliance off and on again and
check whether it is cooling.
The appliance decides independently whether
automatic Super freezing is required and
automatically switches it on or off.
en
41
Advertenties
Inhoudsopgave
