Inhoudsopgave
Advertenties
Control panel
The control panel consists of two dials:
The mode selector dial with 4 positions is
located on the left:
-
O or off
-
fan only
-
1500W power (low)
-
3000W power (high)
The continuously adjustable thermostat dial is
located on the right.
Location and Connection
Remove all packaging material and keep out of reach of children. After removing
packaging, check the appliance for damage or other signs that could indicate a
fault/defect/malfunction. In case of doubt, do not use the appliance, but contact
your vendor for inspection or replacement.
Select a suitable location for the device taking into account all the
aforementioned warnings in this manual.
Make sure the heater is switched off (switch to O position), then plug into a
correctly functioning, properly grounded socket.
Set-up and Operation
If the heater is being used for the first time (or if you want to reset the desired
temperature), turn the thermostat dial to the maximum position (clockwise as
far as it goes).
With the mode selector dial, adjust the heater to suit your preferences: fan only,
low power or high power.
Once the temperature in the area being heated has reached the right level,
slowly turn the thermostat dial anticlockwise until you hear a soft click; leave the
dial in that position. The heater will automatically maintain the temperature at
this level. It does this by switching the heating elements off and on when the
temperature rises or falls too much.
Note! After the thermostat has switched the heating elements off, the fan will
keep turning. This means that the air is constantly moved, allowing the heater to
accurately detect if the area is cooling down.
The thermostat dial is continuously adjustable. A higher temperature is set by
turning it clockwise; a lower temperature by turning it anticlockwise.
29
Advertenties
Inhoudsopgave
