Inhoudsopgave
Advertenties
B
Adjusting salt consumption
• The dishwasher is designed to allow for adjustment in the amount of salt consumed based
on the hardness of the water used. This is intended to optimise and customise the level of
salt consumption.
• Please follow the steps below for adjustment in salt consumption.
1. Open the door, switch on the appliance;
2. Within 60 seconds after the appliance was switched on, press the Program button ">" for
more than 5 seconds, then enter the water softener setting mode.
3. Press the '>' button again to select the proper set according to your local environment, the
setting will change in the following sequence: H3->H4->H5->H6->H1->H2;
4. Without operation in 5 seconds or press the Power button to complete the setup and exit
the setup mode.
WATER HARDNESS
German
French
°dH
°fH
0 - 5
0 - 9
6 - 11
10 - 20
12 - 17
21 - 30
18 - 22
31 - 40
23 - 34
41 - 60
35 - 55
61 - 98
1°dH=1.25 °Clarke=1.78 °fH=0.178mmol/l
The factory setting: H3
Every cycle with a regeneration operation consumes additional 4.0 litres of water, the
1)
energy consumption increases by 0.06 kWh and the program extents by 10 minutes.
NOTE
Please check the "Loading The Salt Into The Softener", if
your dishwasher lacks salt.
Using the appliance
British
Mmol/l
°Clarke
0 - 6
0 - 0,94
7 - 14
1,0 - 2,0
15 - 21
2,1 - 3,0
22 - 28
3,1 - 4,0
29 - 42
4,1 - 6,0
43 - 69
6,1 - 9,8
27
Regeneration
Water softner
occurs every
level
X program
sequence
H1
regeneration
H2
H3
H4
H5
H6
EN
Salt
consumption
(gram/cycle)
1)
No
0
10
9
5
12
3
20
2
30
1
60
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
