Advertenties
Bringing plunge unit to installation position
The plunge unit has an installation position at which the clamping screw is accessible through
the installation window. The latching lever enables you to set the installation position.
When you flip the latching lever back (basic position), the plunge unit snaps back. Hold the
product by the main grip to control the return of the plunge unit to the initial position.
1. Position the product in such a way that you can plunge with the maximum cutting depth (e.g. at a
table edge).
2. Open the installation flap for saw blade installation.
3. Set the cutting depth setting indicator to the maximum value (1).
4. Flip the latching lever up (installation position) (2).
5. Press and hold down the switch-on interlock (3) and plunge the plunge unit to the installation
position.
▶
The plunge unit engages in the installation position with an audible click.
▶
The clamping screw is visible, centered in the installation window.
Removing the saw blade
WARNING
Risk of burns and cut injuries at saw blade, clamping screw and clamping flange The
consequences can be burns and cut injuries.
▶
Wear protective gloves when changing saw blades.
1. Bring the plunge unit to the installation position.
2. Press and hold down the spindle lock button (1).
3. Use the hex key to slacken the clamping screw (2).
Use the direction-of-rotation arrow for guidance: To slacken the clamping screw, turn it in
the direction of rotation of the saw blade.
4. Remove the clamping screw and the clamping flange.
5. Ease the saw blade down and out of the guard.
If necessary, the mounting flange can be removed for cleaning.
Installing the saw blade
Check that the blade to be fitted complies with the technical requirements and that it is well
sharpened. A sharp saw blade is an essential requirement for a perfect cut.
Before every use, always select the saw blade that is suitable for the material you are going to cut.
1. Bring the plunge unit to the installation position.
2. Clean the mounting flange and the clamping flange (1).
3. Slip the mounting flange right way round on to the arbor.
4. Insert the new saw blade (2).
▶
Note the direction-of-rotation arrows on the saw blade (3) and on the guard (4). Both direction-
of-rotation arrows must point in the same direction.
5. Install the clamping flange the right way round.
6. Install the clamping screw.
7. Press and hold down the spindle lock button (5).
8. Use the hex key to tighten the clamping screw (6).
Use the direction-of-rotation arrow for guidance: To tighten the clamping screw, turn it
opposite to the direction of rotation of the saw blade.
*2373402*
4
5
6
,
2373402
3
32
32
32
Advertenties
