Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Step Seven: Placing the upper shaft part
1. Lift the upper shaft section to horizontal line B;
2. Screw(12) the upper shaft part to the shaft bracket.
Operation
The control panel is located on the front of the hood. It has a
user-friendly design and is easy to operate.
Once you plug it in, you will hear a beep and all the lights will light up for 1 second.
ON/OFF: To turn on the motor power press the
working at position one (1), this is also shown on the display. When the hood is on and you
press the
button and the motor goes into lag mode for 3 minutes. After the three minutes,
the hood will turn off. If you press button
immediately turned off.
Lights on/off
The lights are turned on or off by touching this control surface.
Increase airflow
After touching this control surface, the airflow will be continuously increased until the highest
level is reached.
Reducing airflow
After touching this control surface, the airflow will be lowered each time until the lowest level
is reached.
Lighting
Reduce airflow
on/off
during the after-run position, the hood is
Digital screen
CENDO - Series 5 Exhaust hoods manual
button, the motor starts up and starts
Increase airflow
On/off
switch
43
43
Advertenties
Inhoudsopgave
Probleemoplossen
