Inhoudsopgave
Advertenties
Operation
Preparation
• Carefully remove the hand blender and all accessories from the packaging.
• Remove all packaging components and keep the complete packaging.
• Clean the hand blender and its accessories before they come into contact with
food. See "Cleaning and care" (page 28).
Setting up the hand blender and electrical preparation
• Insert the plug into the mains socket.
• Place the hand blender in the charger until the battery is fully charged. Upon deliv-
ery, the battery is only partially charged.
LED display (charging and working)
LED display: blender is in the charger
1–4 LEDs flashing ascending
4
LEDs lit briefly when placed
on charger
LED display: switching on the blender (blender is not in the charger)
When the multifunction button is pressed, the current charge status lights up for 1
second.
cordless
26
• Plug the charger cable into the base of the charger, then in-
sert the cable into the slot provided and pull the cable out-
wards.
Attention: only cable duct 2 may be used!
• Place the charger (fig. 2) on a flat, non-slip surface in the im-
mediate vicinity of a mains outlet.
=
=
While the large multifunction button is pressed (1-2 seconds),
a blue light appears as confirmation for the switch-on mode. At
the same time, the 4 LEDs indicate the battery charge level.
After releasing the large multifunction button, the LEDs of the
charge level indicators go out and only the large multifunction
button lights up. As long as the multifunction button is lit, work
can be done. If the button is unlit, see further down in this chap-
ter, "LED display without light".
battery in charging mode
battery charged and ready for use
Advertenties
Hoofdstukken
Inhoudsopgave
