Ambient temperature below 16°C or above 38°C will hinder the performance of the
appliance.
This unit is not designed for use in a garage or any other outside installation.
Do not set up the device in a hot, wet or extremely damp environment or near flammable
material.
The device requires an adequate flow of air in order to operate correctly. Leave a
clearance of 15 cm around the appliance.
WARNING! Do not close the ventilation openings in the device housing.
The electrical socket must be easily accessible so that the power lead can be
disconnected easily, in the case of an emergency.
The installation and assembly of this device in non-stationary setup locations (e.g. on
ships) must be carried out by specialist companies / electricians, provided they guarantee
the prerequisites for the safe use of this device.
For energy saving reasons please ensure that the door is closed when the appliance is
turned on.
12.5.2
Legs/feet
There are FOOT (3 bigger feet and 1 small foot).
To level your appliance, adjust the front legs at the bottom of the appliance.
12.5.3
Wine shelves
Remove all bottles from the shelves. Lift the shelf upwards and the gently pull it out. Any of
the wine shelves can be removed to accommodate larger bottles.
usual shelf
12.5.4
To remove a shelf
Remove all bottles from the shelves. Lift the shelf upwards and the gently pull it out.
(eventually untighten the screws).
► Ensure that the tabs are firmly engaged in place before storing any bottles.
► Any of the wine shelves can be removed to accommodate larger bottles.
► Spread your bottles out as evenly as possible over the shelves, so weight is not
concentrated in one point; and make sure your bottles will not touch the back of the
cabinet.
bottom shelf
Please note
top shelf
33