Inhoudsopgave
Advertenties
when the skin is dry.
2. Fit the required MicroPedi roller (2 or 8) onto the spindle (3) of the callus remover as
described in the chapter "Ejecting and inserting a MicroPedi roller".
3. Remove the protective cap (1).
4. Press down the locking button (5) on the on/off switch (6).
5. Slide the on/off switch up to switch the callus remover on.
6. Move the MicroPedi roller carefully over the parts of the skin you wish to treat, applying
light pressure.
If you use too much pressure, the MicroPedi roller will stop.
Only ever use on the skin for two or three seconds and then check the result.
7. Once you have finished the treatment or want to take a lengthy break, switch off the
callus remover by sliding the on/off switch down.
8. At the end of your skin care session, clean the callus remover as described in the chapter
"Cleaning and maintenance".
Cleaning and maintenance
NOTE! Risk of damage!
If you use the wrong cleaning products or
cleaning implements, you may damage the cal-
lus remover.
• Do not use hard, rough or abrasive cleaning prod-
ucts or implements.
Cleaning the callus remover
Clean the callus remover whenever you have used it as follows:
1. Take the MicroPedi roller (2 or 8) out of the callus remover as described in the chapter
"Ejecting and inserting a MicroPedi roller".
2. Check that the battery compartment cover (7) is securely turned to the lock position.
3. Remove any dirt, dust and remnants of skin from the callus remover and the MicroPedi
rollers using a dampened cloth or shortly hold the parts under running lukewarm water.
4. Wipe the callus remover and the MicroPedi roller dry with a cloth.
5. Once clean and dry, store the callus remover and MicroPedi rollers in a cool and dry place.
Replacing MicroPedi rollers
The MicroPedi rollers (2 or 8) should only be used a couple of times depending on the
frequency of use and size of the areas of skin treated.
• Always replace the MicroPedi rollers:
• when the MicroPedi rollers look worn;
13
EN
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
