Inhoudsopgave
Advertenties
which roller is suitable for which treatment purpose.
No.
2
8
With very rough skin, we recommend always using the dark-grey MicroPedi roller first, followed
by the light grey one.
Ejecting and inserting a MicroPedi roller
NOTE! Risk of damage!
If you eject an inserted MicroPedi roller from the
spindle of the callus remover while the device is
switched on, you may damage the callus remover.
• Never eject a MicroPedi roller that is still rotating
when the callus remover is switched on.
• Always switch the callus remover off first before
replacing the MicroPedi roller.
EN
Ejecting MicroPedi roller
1. Check that the callus remover is switched off.
2. Slide down the locking bar for the MicroPedi rollers (4) on the right-hand side of the callus
remover.
3. The MicroPedi roller inside will be ejected.
4. Pull the MicroPedi roller off the spindle (3) of the callus remover by moving outwards.
Inserting MicroPedi roller
1. Fit the required MicroPedi roller (2 or 8) onto the spindle (3) in the casing of the callus remover.
2. Carefully press the MicroPedi roller right onto the spindle until you hear the locking bar for
the MicroPedi rollers (4) click into place.
3. Shake the callus remover lightly to check whether the MicroPedi roller is securely fastened.
The callus remover is now ready for use.
Using the callus remover
1. Clean your skin before treatment with the callus remover. The best results are obtained
Colour
Light grey
Dark grey
Use
This surface of this MicroPedi roller is finer. Use this
MicroPedi roller to remove rough skin or for treat-
ment after using the dark-grey MicroPedi roller.
This surface of this MicroPedi roller is coarser. Use
this MicroPedi roller to remove very rough skin.
12
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
