Advertenties
Transport and storage
Transport
▶
Do not transport this product with an accessory tool installed.
▶
Make sure that the equipment is held securely throughout all transport operations.
▶
After transporting, always check all visible parts and controls for signs of damage and make sure
that they all function correctly.
Storage
▶
Always store this product with the electric supply cable unplugged from the electricity supply.
▶
Store this product in a dry place, where it cannot be accessed by children or unauthorized persons.
▶
After a long period of storage, always check all visible parts and controls for signs of damage and
make sure that they all function correctly.
Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem
by yourself, please contact Hilti Service.
Trouble or fault
The saw blade drops out.
The saw blade cannot be
inserted.
The orbital action cannot be
adjusted.
The orbital action doesn't
work.
The power tool gets very
hot.
Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled.
The materials must be correctly separated before they can be recycled. In many countries, your old
tools, machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti
representative for further information.
▶
Do not dispose of power tools, electronic equipment or batteries as household waste!
21
Possible cause
The saw blade is not correctly
engaged.
The clamping system is clogged
with foreign matter.
The clamping system is clogged
with foreign matter.
Foreign matter in the orbital-
action adjusting lever groove.
The orbital-action mechanism is
clogged with foreign matter.
The orbital-action adjusting lever
is in position "0".
Electrical fault.
Action to be taken
▶
Repeat the insertion proce-
dure.
▶
Make sure that the blade
holder is fully open and that
the saw blade is pushed all
the way in against the spring
resistance.
▶
Clean out the blade holder.
▶
Clean out the blade holder.
▶
Clean out the orbital-action
adjusting lever groove.
▶
Check whether foreign matter
is present in the area of the
orbital-action fork and clean it
out.
▶
Adjust it to the desired setting.
▶
Switch off immediately and
unplug the power cord from
the electricity supply.
▶
Allow the power tool to
cool down and consult Hilti
Service.
2150159
*2150159*
Advertenties
