Advertenties
Cutting angle (left/right)
Dust removal adapter outside diameter
Noise information and vibration values
The sound pressure and vibration values given in these instructions were measured in accordance
with a standardized test and can be used to compare one power tool with another. They can also be
used for a preliminary assessment of exposure.
The data given represent the main applications of the power tool. However, if the power tool is used
for different applications, with different accessory tools, or is poorly maintained, the data can vary.
This can significantly increase exposure over the total working period.
An accurate estimation of exposure should also take into account the times when the power tool is
switched off, or when it is running but not actually being used for a job. This can significantly reduce
exposure over the total working period.
Identify additional safety measures to protect the operator from the effects of noise and/or vibration,
for example: maintaining the power tool and accessory tools, keeping the hands warm, organization
of work patterns.
Detailed information on the versions of the EN 62841 standards applied here is to be found in
the reproduction of the declaration of conformity
Noise emission values
Sound power level (L
Uncertainty for the sound power level (K
Sound pressure level (L
Uncertainty for the sound pressure level (K
Total vibration
Vibration emission value for sawing wood sheets (a
Vibration emission value for sawing sheet metal (a
Uncertainty (K)
Using extension cords
WARNING
A damaged supply cord presents a hazard! Do not touch the supply cord or extension cord if
damaged while working. Disconnect the supply cord plug from the power outlet.
▶
Check the appliance's supply cord at regular intervals and have it replaced by a qualified specialist
if found to be damaged.
• Use only extension cords of a type approved for the application and with conductors of adequate
gauge (cross section). The power tool may otherwise suffer a drop in performance and the extension
cord may overheat.
• Check the extension cord for damage at regular intervals.
• Replace damaged extension cords.
• When working outdoors, use only extension cords that are approved and correspondingly marked
for this application.
17
)
WA
)
pA
168.
)
WA
)
pA
)
h,B
)
h,M
2150159
SJT 6
0°, 15°, 30°, 45°
27.5 mm
SJT 6
98 dB(A)
5 dB(A)
90 dB(A)
5 dB(A)
SJT 6
12.1 m/s²
10.7 m/s²
1.5 m/s²
*2150159*
Advertenties
