Advertenties
Operating Manual SATAjet 1500 B RP/HVLP
■ Never point the spray gun at human beings.
■ Comply with the local regulations for safety, accident prevention, occu-
pational health and safety and environmental protection.
■ Heed the accident prevention regulations.
3. Intended Use
The spray gun is used to apply paints, lacquers and other sprayable me-
dia on suitable substrates.
4. Description
The compressed air required for spraying is supplied at the compressed
air connection. Pull the trigger to the first pressure point to activate the
pre-air control. Continue pulling the trigger to pull the paint needle out of
the fluid tip: the material flows without pressure out of the fluid tip and is
atomised by the compressed air flowing out of the air cap.
5. Scope of Delivery
■ Spray gun with nozzle set RP / HVLP and gravity flow cup
■ Tool kit
■ CCS clips
■ Operating Instructions
Alternative version
■ Gravity flow cups made of PVC or aluminium with different capacities
After unpacking, check:
■ Spray gun damaged
■ Complete scope of supply
6. Technical Design
6.1. Spray gun
Anti-drip device
[1-1]
Round / flat fan control
[1-2]
Material flow control
[1-3]
[1-4]
Counter nut material flow
control
Air micrometer (aif flow
[1-5]
control knob)
Air micrometer (air flow
[1-6]
control) locking screw
[1-7]
Air piston (not visible)
[1-8]
Compressed air connection
G ¼ „ (male thread)
ColorCode-System (CCS)
[1-9]
[1-10] Spray gun handle
[1-11] Trigger
[1-12] Nozzle set consisting of air
cap, fluid tip (not visible),
paint needle (not visible)
[1-13] Spray gun connection with
QCC
[1-14] Gravity flow cup connection
with QCC
[1-15] Paint strainer (not visible)
[1-16] Gravity flow cup
EN
123
Advertenties
