Inhoudsopgave
Advertenties
English
NOTE: The Bass and Treble controls circuits are bypassed to ensure
the purest possible sound, which is defaulted. Turn the Bass / Treble
rotary knob if you want to adjust the Controls.
Source Input Selector 9G
Press the corresponding input button on the front panel
control
G
to select the desired listening source.
LED Dimmer Control B
To change the brightness of the Power indicator above the Power button,
the LEDs above the Source selectors and the Volume rotary knob LED on
the front panel, press the DIM
Protection Circuit
The unit has both thermal and over-current protection circuitry that
protects the amplifier against damage in the event of extreme or faulty
operating conditions. The protection circuits are independent of the audio
signal and have no impact on sonic performance. Instead, the protection
circuits monitor the temperature of the output devices and shut down
the amplifier if temperatures exceed safe limits.
Most likely, you will never see this protection circuitry in action. However,
should a faulty condition arise, the amplifier will stop playing and the
POWER indicator
2 2
on the front panel will turn red.
If this happens, turn the amplifier off. Let it cool down for several minutes,
and attempt to identify and correct the problem that caused the protection
circuitry to engage. When you turn the amplifier back on, the protection
circuit will automatically reset and the POWER indicator
blue, indicating that the amplifier is operating normally.
In most cases, the protection circuitry activates because of a fault condition
such as shorted speaker wires, or inadequate ventilation leading to an
overheating condition. In very rare cases, highly reactive or extremely low
impedance speaker loads could cause the protection circuit to engage.
If the protection circuitry triggers repeatedly and you are unable to isolate
and correct the faulty condition, contact your authorized Rotel dealer for
assistance in troubleshooting.
9
button on the remote control.
B
2 2
Troubleshooting
Most difficulties in audio systems are the result of incorrect connections,
or improper control settings. If you encounter problems, isolate the area
or remote
of the difficulty, check the control settings, determine the cause of the
fault and make the necessary changes. If you are unable to get sound
from the unit, refer to the suggestions for the following conditions:
Power Indicator Is Not Illuminated
The Power Indicator should be illuminated whenever the unit is plugged
into the wall power outlet and the Power button is pushed in. If it does
not light, test the power outlet with another electrical device, such as a
lamp. Be sure the power outlet being used is not controlled by a switch
that has been turned off.
Fuse Replacement
If another electrical device works when plugged into the power outlet,
but the Power Indicator of the unit does not light when plugged into
the same outlet and the Power Switch is pushed in, it indicates that the
internal power fuse may have blown. If you believe this has happened,
contact your authorized Rotel dealer to get the fuse replaced.
No Sound
Check the signal source to see if it is functioning properly. Make sure the
cables from the signal source to the unit inputs are connected properly.
Be sure the Listening Selector is set to the proper input. Check the wiring
between the unit and the speakers.
Cannot Connect via Bluetooth
If you cannot pair your Bluetooth enabled device to the unit, delete the
memory of the previous connection on your device. On your device this is
should be
often listed as "Forget this Device". Then try to make the connection again.
11
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
