Inhoudsopgave
Advertenties
3. ASSEMBLY INSTRUCTIONS | ROBOT & CHARGING STATION
REMOVE PROTECTION
1. Before using the robot, remove the protective strip on the robot and remove
the protective film on the charging station.
Direction control
2. Placing and charging: Place charging station against the wall and on a flat
ground. Do not place items within the range of 0.5m left and right and 1.5m in
front.
3. lnstalling side brush: lnstall the side brush according to the left and right
(L/R).
During the cleaning process, the robot will automatically switch to
"Recharging" mode when the battery is low and automatically finds the
charging station to charge. You can also command the robot to switch to
"Recharging" mode throught the "Recharging" button on the remote control.
WARNING | CHARGING STATION
1. The charging station cannot be used in environments with strong reflection
such as direct sunlight and nearby mirrors. Direct sunlight will interfere with the
recharging signal and consequently, the robot may be unable to return to the
charging station.
2. In order to ensure that the robot operates in full, please fully charge it before
use. The charging time is about 5 hours.
3. If the battery level is less than 20% the robot will not work. Please charge it.
While operating the robot will return to the station automatically. If the level is
less than 20% it will be powered off automatically.
4. If the charging station is relocated, the robot may fail in positioning.
5. When charging, do not attach the water tank to ensure the safety of charging
and prevent damage due to water.
EN
7
Advertenties
Inhoudsopgave
