Inhoudsopgave
Advertenties
Events card
Pos.
Indicates the memory position
Code
Indicates the device code
Date
Indicates the date and time of the event
Indicates the type of event:
Channel 1/2/3/4: Indicates the channel enabled
PRG channel: The device has opened the receiver programming
Event
Anti-panic: Indicates that the anti-panic function has been enabled in stations
Alarm Function: Indicates that the alarm function has been enabled in stations
AntiPBK Warning: Indicates that the anti-passback function has been enabled in stations
Code absent: Code not programmed in the memory
4.2.6 Copy to int. memory
This allows for the data on the memory card to be copied to the internal programmer memory.
Insert the memory card in the corresponding slot and choose the sector of the internal memory to be used, from 1 to 4.
Press Intro.
N.B.: The data existing in the sector selected will be lost.
4.2.7 Save Mem
This allows for the data on the internal programmer memory to be copied to the memory card.
Insert the memory card in the corresponding slot and choose the sector of the internal memory to be used, from 1 to 4.
Press Intro.
N.B.: The data existing on the memory card will be lost.
4.2.8 Config channel
Allows for a specific relay or relays to be configured for activation with each channel.
4.2.9 Add instal code
This allows for the installer code to be added to receivers and control boxes.
Insert the memory card in the corresponding slot and follow the on-screen instructions.
4.2.10 Remove instal c.
This allows for the installer code to be removed from receivers and control boxes.
Insert the memory card in the corresponding slot and follow the on-screen instructions.
4.2.11 Add PIN code
This allows for the PIN code to be added to receivers.
Insert the memory card in the corresponding slot and follow the on-screen programmer instructions.
4.3 CONTROL PANELS
Connect the programmer to the panel using the cable supplied for this purpose.
4.3.1 Configuration
This allows for the parameters applicable to the panel to be read and/or configured and will be displayed on screen
depending on the panel model connected.
The entire manoeuvre must be programmed after modifying any panel parameter.
4.3.2 Copy to internal m.
This allows for the memory data to be copied from the panel to the internal programmer memory.
Connect the programmer to the panel using the connector supplied and choose the sector of the internal memory to be
used, from 1 to 4.
Press Enter.
N.B.: The data existing in the sector selected will be lost.
4.3.3 Save Mem
This allows for the data on the internal programmer memory to be copied to the panel memory.
Connect the programmer to the panel using the connector supplied and choose the sector of the internal memory to be
used, from 1 to 4.
Press Enter.
Note 1: The data existing on the memory card will be lost.
Note 2: It is only possible to copy the data to a panel of the same type and version as that from which the data was
previously extracted.
COD.1247021_PROGMAN_v1.2
12
Advertenties
Inhoudsopgave
