Download Print deze pagina

Beginning Work With The Machine; End Of Operation - Taski ergodisc HD Handleiding

Advertenties

Beschikbare talen
  • NL

Beschikbare talen

  • DUTCH, pagina 140

Beginning work with the machine

Attention:
Always wear slip-resistant shoes and ap-
propriate working clothes when working
with this machine!
Attention:
Start familiarization with the machine by
making your first driving attempts in a free
area.
Cleaning start
• Insert the plug into the mains socket.
The display lights up.
• Hold the power supply cord in your hand.
Ensure that the power supply cord cannot come into con
tact with the tool.
• Hold the machine with both hands.
• Push the safety switch and operate
the operating lever at the same time.
The tool is activated.
Notice:
Lifting the guide rod slightly moves the ma-
chine to the right, lowering the guide rod
slightly moves the machine to the left.
Stairs
Notice:
The machine must only be transported
over stairs by two persons.
• Switch off the machine.
• Remove the plug from the mains socket.
Attention:
Lifting the machine can be dangerous un-
der any circumstances!
Stumbling may cause personal injuries or
machine damage.
• Using your hand or foot, rotate the
tool away from the tool connection.
• To lift the machine, one person grips
the machine at the brush cover and
the other person takes the machine
handle.

End of operation

• Release the operating lever.
• Remove the plug from the mains socket.
Attention:
The machine must now be emptied and
cleaned. Switch off the machine (main
switch) and remove the plug from the
mains socket.
• Tilt the machine slightly backwards.
• Using your hand or foot, rotate the
-
• Put the machine slowly on the pro-
• Pull the adjusting lever and tilt the
• Release the adjusting lever to lock
• Clean the main cord with a damp
Emptying the cleaning solution
Notice:
Drain water or cleaning solution must be
disposed of in compliance with the nation-
al regulations.
Notice:
When draining the recovery tank, the reg-
ulations of the detergent supplier regard-
ing personal protective equipment must be
observed.
• Remove the water tank from the machine and empty it.
• Empty the product tank of the dispensing unit.
tool away from the tool connection.
tective ring.
guide bar slowly upwards until it is
completely upright.
the guide bar.
cloth and roll the cord loosely around
the machine handle and cable hook.
EN
49

Advertenties

loading