Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
en - Problem solving guide
The wash programme does not start
Problem
The display remains dark,
and the Start/Stop sensor
control does not light up
or flash.
The following appears in
the display:
F -Door lock
fault. You can continue by
pressing the "Start/Stop"
button
The programme does not
start when Spin has been
selected.
The display is dark and the
Start/Stop sensor control
is flashing slowly.
178
Cause and remedy
There is no power to the washing machine.
Check whether the washing machine is switched on.
Check whether the washing machine is connected to the
power supply.
Check whether the fuse has tripped.
The washing machine has switched off automatically to
save energy.
Switch the washing machine back on with the button.
The door is not locked properly. The door lock could not
engage.
Close the door again.
Start the programme again.
If the fault message appears again, contact the Cus-
tomer Service Department.
You have not yet completed the initial commissioning pro-
cess.
Perform the initial commissioning process as described
in these instructions.
The display has switched off automatically to save energy.
Touch any of the controls. The display switches back on.
Advertenties
Hoofdstukken
Inhoudsopgave
