Download Inhoudsopgave Inhoud Print deze pagina

Installation Under A Wall Cupboard; Dismantling - SilverCrest SKR D1 B2 Bedienings- En Veiligheidsinstructies

Dab+ keukenradio
Inhoudsopgave

Advertenties

Beschikbare talen
  • NL

Beschikbare talen

The surfaces of some items of furniture might
 
contain components that can soften the rubber
feet of the product . If necessary, place a mat
under the product's rubber feet .
Set up or mount the product in such a way
 
that the provided ventilation openings and the
loudspeaker
are not covered .
[
15 ]
Do not operate the product in a hot, wet or
 
extremely damp environment or in the vicinity
of flammable materials .
The mounting location must be selected so that
 
the product is not exposed to vapours . Do not
install the product directly over a hotplate .
˜ Installation under a wall
cupboard
Using the supplied mounting plate
install the product e .g . under a wall cupboard .
Proceed as follows to mount the product:
Slide the mounting plate
 
remove it from the product .
3 .1 cm
6 .3 cm
, you can
10 ]
[
to the rear and
10 ]
[
Find a suitable installation location for the
 
product (see "Requirements for the set-up
location") .
Hold the mounting plate
 
installation location . Ensure that the front edge
of the mounting plate is approx . 3 .1 cm behind
the front of the cupboard so that the product is
flush with the cupboard after installation . The
side edges of the mounting plate
spaced approx . 6 .3 cm away from adjacent
cabinets or walls .
Mark the 4 mounting points with a pencil .
 
Using a pin or nail, make a small depression at
 
the respective marking points . In hardwoods,
drill a shallow hole in the markings using a
Ø 2 .5 mm wood drill bit .
If required, place the supplied spacers
 
between the cupboard and the mounting plate .
If you are using the spacers
the long mounting screws
Screw the mounting plate
 
mounting screws (
[
18 ]
With the top of the product against the
 
mounting plate
, push the product back until
10 ]
[
it clicks into place .
Check to ensure that the product is firmly in
 
position and safely route the power cable and
the wire aerial .
˜ Dismantling
Pull the product forwards off the mounting
 
plate
.
10 ]
[
Unscrew the screws (
 
mounting plate and remove the mounting
plate
from the wall cupboard .
10 ]
[
under the
10 ]
[
must be
[
10 ]
[
17 ]
, you will need
17 ]
[
.
18 ]
[
tight using the
10 ]
[
or
) .
[
19 ]
or
) on the
[
18 ]
[
19 ]
GB/IE/NI
13

Advertenties

Inhoudsopgave
loading

Deze handleiding is ook geschikt voor:

356445 2004Hg06858aHg06858b

Inhoudsopgave