Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
correctly. The thermostat must be set to five degrees or to frost protection mode. Check the
connections on the power supply cable and ensure a fixed connection of between 4 and 5
Nm.
Treat any minor damage to the charging station with corrosion-resistant paint in the right
shades (Ecotap® green ral.6018 & white ral.9016).
Treat the cylinder locks with graphite powder or a suitable oil product if they require any
maintenance.
21. TRANSPORTATION AND STORAGE
Transport the charging station (the core housing all of the technology) upright and prevent
the coating from being damaged; any such damage might result in corrosion. Provided that
they are properly protected to prevent them being damaged, the caps can be transported in
a variety of positions. The charging station should be stored in a dry, damp-free area.
22. IN CASE OF MALFUNCTIONS
In case the DUO charging station is not functioning (properly), please contact the Ecotap®
24/7 helpdesk immediately (phone number: 0031 (0) 411-745020) or a licensed mechanic
in possession of measuring and testing equipment with auto simulation.
WARNING!
All work performed on and modifications made to the charging station must comply with
NEN1010 at the very least.
23. OPERATION AND USE OF CHARGING STATION
This charging station is operated via a charging pass.
The charging pass first needs to be registered in the Open Charge Point Protocol (OCPP).
This necessary registration can be completed by phone by calling Ecotap® B.V. at 0031 (0)
411-210210 during office hours.
As soon as the registration has been completed, the charging station can be operated with
any electric vehicle charging card (EV charging card) or other suitable cards, mobiles and
tags.
The charging station' s green light will blink at regular intervals when the station is not being
used.
Use: You start the procedure by holding the charging pass in front of the scanner; you will
hear a beep and the green light will start blinking.
First of all, the plug will be locked into the Mennekes charging socket.
The charging station will then communicate with the vehicle and the back office system,
and then once all safety regulations and payment arrangements have been checked, the
maximum amount of voltage permitted will be transmitted.
The charging procedure will now start automatically, and the light will turn blue. When the
charging process is finished and you hold your charging card in front of the scanner again,
you will hear two beeps and the green light will start blinking until the plug is unlocked. You
may now remove the plug.
26. www.ecotap.nl
01-05-23
Advertenties
Hoofdstukken
Inhoudsopgave
