Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Note:
Make sure that the arrows on the 2
washers point up.
7. Remove the tape from the adjustment lever (I)
and discard the tape.
8. Do a check of the operator presence control.
To do a check of the operator presence
Refer to
control (OPC) on page 7 .
WARNING:
product if the operator presence
control is defective.
To install the engine cover piece
1. Align the front tab on the engine cover piece with
the cut-out in the engine cover.
2. Align the rear tabs on the engine cover piece
with the cut-outs in the engine cover.
3. Push down the engine cover piece on the engine
cover.
To assemble the grass catcher
1. Unfold the bag and put it right side up.
1706 - 004 - 14.07.2023
Do no operate the
2. Put the front frame (A) up through the fabric
loops (B) on each side of the grass catcher.
3. Click the bottom of the front frame into the front
of the grass catcher bottom.
4. Move the fabric loop segments at the ends of
the bag onto the top of the grass catcher frame
tubes.
5. Remove the 2 hex bolts (C) from the front of the
top grass catcher frame.
6. Install the hex bolts through the holes at the top
of the front grass catcher frame.
7. Turn the hex bolts into the inner nuts on the top
grass catcher frame tubes.
8. Remove the 2 locknuts (D) at the bottom of the
front grass catcher frame.
D
9. Unfold the 2 cross braces (E) and attach them to
the bolts at the bottom corners of the front grass
catcher frame.
10. Install and tighten the 2 locknuts.
B
C
A
E
13
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
