Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
ENGLISH (Original instructions)
1.
Red indicator
2.
Button
3.
Battery cartridge
4.
Star marking
5.
Switch trigger
6.
Lamp
7.
Reversing switch lever
8.
Speed change lever
9.
Action mode changing ring
10. Arrow
11. Adjusting ring
SPECIFICATIONS
Capacities
No load speed
Blows per minute
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Intended use
The tool is intended for impact drilling in brick, concrete
and stone. It is also suitable for screw driving and drilling
without impact in wood, metal, ceramic and plastic.
General Power Tool Safety
Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and
instructions for future reference.
CORDLESS HAMMER DRIVER
DRILL SAFETY WARNINGS
1. Wear ear protectors when impact drilling.
Exposure to noise can cause hearing loss.
2. Use auxiliary handle(s), if supplied with the tool.
Loss of control can cause personal injury.
Explanation of general view
12. Graduation
13. Groove
14. Protrusion
15. Steel band
16. Grip base
17. Side grip
18. Sleeve
19. Bit holder
20. Bit
21. Depth rod
22. Clamp screw
Model
Drilling into concrete
Drilling into steel
Drilling into wood
Fastening wood screw
Fastening machine screw
High (2)
Low (1)
High (2)
Low (1)
Overall length
Net weight
Rated voltage
3. Hold power tool by insulated gripping surfaces,
ENE079-1
when performing an operation where the cutting
accessory may contact hidden wiring. Cutting
accessory contacting a "live" wire may make exposed
metal parts of the power tool "live" and could give the
operator an electric shock.
4. Hold power tool by insulated gripping surfaces,
GEA010-1
when performing an operation where the fastener
may contact hidden wiring. Fasteners contacting a
"live" wire may make exposed metal parts of the
power tool "live" and could give the operator an
electric shock.
5. Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
6. Hold the tool firmly.
7. Keep hands away from rotating parts.
8. Do not leave the tool running. Operate the tool
only when hand-held.
9. Do not touch the bit or the workpiece immediately
GEB056-5
after operation; they may be extremely hot and
could burn your skin.
23. Hook
24. Screw
25. Blow-out bulb
26. Limit mark
27. Rear cover
28. Screws
29. Arm
30. Spring
31. Recessed part
32. Carbon brush cap
33. Hole
DHP458
16 mm
13 mm
76 mm
10 mm x 90 mm
6 mm
-1
0 - 2,000 min
-1
0 - 400 min
-1
0 - 30,000 min
-1
0 - 6,000 min
225 mm
2.3 kg
D.C. 18 V
5
Advertenties
Inhoudsopgave
