Download Inhoudsopgave Inhoud Print deze pagina

Defrosting Of The Appliance (Fresh Food); Replacing The Interior Light Bulb; Cleaning And Care - Beko TSE 1411 Gebruiksaanwijzing

Inhoudsopgave

Advertenties

Beschikbare talen
  • NL

Beschikbare talen

  • DUTCH, pagina 33
en
Defrosting of the appliance
The fridge compartment defrosts automatically.
The thawing water flows through the drain
channel into a collection container at the back
of the appliance (Fig. 5).
During defrosting, water droplets form at the
back wall of the fridge due to the evaporation.
If not all of the drops run down, they may
freeze again after defrosting competes.
Remove them with a soft cloth dampened with
warm water. Do not use hard or sharp objects.
Check the flow of the thawed water from time
to time. It may become blocked occasionally.
Clean it with a q-tip or similar (see the section

"Cleaning and care").

Replacing the interior
light bulb
(Fig. 4)
Should the light fail to work, proceed as follows.
1- Switch off the circuit breaker or unplug
the power cable.
You may find it useful to remove shelves for
easy access.
2- Use a flat tipped screwdriver to remove the
light diffuser cover.
3- First check that the bulb hasn't worked loose
by ensuring it is screwed securely in the holder.
Plug in the appliance and switch it on.
If the bulb works, replace the light cover by
inserting the rear lug and pushing up to locate
the front two lugs.
4- If the light still fails to work, switch off the
circuit breaker or unplug the power cable.
Replace the bulb with a new 15 watt (max)
screw cap (SES) bulb.
5- Carefully dispose of the burnt-out light bulb
immediately.
Replacement light bulb can easily be obtained
from a good local electrical or DIY store.
Cleaning and care
Interior and Exterior Surfaces
Attention
Always unplug the power cable or switch
off the circuit breaker before cleaning.
Clean the exterior using lukewarm water and
a mild detergent.
Never use detergents, abrasive or acidic
agents.
Wipe the inside compartment dry.
Be careful to prevent water from getting into
contact with the electrical connections of the
temperature control or the interior light.
If the appliance is not going to be used for a
long period of time, unplug the power cable
remove all food. Clean the appliance and keep
the door open.
To preserve the appearance of your appliance,
you can polish the exterior and the door
accessories with a silicone wax.
Clean the condenser at the back of the
appliance once a year using a brush or a
vacuum cleaner. Dust build-up leads to
increased energy consumption.
Inspect the door gasket at regular intervals.
Clean with water only, and wipe totally dry.
5
en

Advertenties

Inhoudsopgave
loading

Inhoudsopgave