Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Caution: To avoid damage to the bottle
- Do not place in a heated oven, plastic can melt.
- Plastic material properties may be affected by disinfection and high temperatures. This can affect
the fit of the bottle cap.
- Do not leave a feeding teat in direct sunlight or heat, or leave in disinfectant for longer than
recommended because this may damage the product.
Before using the bottle
- Inspect the bottle and feeding teat before each use and pull the feeding teat in all directions to
prevent a choking hazard. Throw away at the first signs of damage or weakness.
- Clean and disinfect the bottle before first use and after every use (see 'Cleaning and disinfecting').
Assembling the bottle
1. The teat is easier to
assemble if you move it
back-and-forth while
pulling it upwards
instead of pulling it up
in a straight line.
5. To remove the cap,
place your hand over
the cap and your
thumb in the dent of
the cap.
2. Make sure you pull
the teat through until
its lower part is aligned
with the screw ring.
3. Make sure you place
the cap vertically onto
the bottle so that the
teat sits upright.
English
4. Screw the screw ring
with teat and cap on
the bottle.
21
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
