Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
11 Testing the Trimmer
► Push the release slide (1) in the direction of the loop
handle with your thumb and hold it there.
► Depress the trigger lockout lever and hold it in that
position.
► Pull the trigger.
► Let go of the trigger, trigger lockout and release slide.
► If the trigger, trigger lockout or release slide is stiff or does
not spring back to the idle position: Do not use your
trimmer and contact your STIHL servicing dealer.
The trigger, trigger lockout or release slide has a
malfunction.
Switching On
► Insert the activation key.
► Push the release slide (1) in the direction of the loop
handle with your thumb and hold it there.
► Depress the trigger lockout lever and hold it in that
position.
► Pull the trigger and hold it there.
The cutting attachment rotates.
► If 3 LEDs flash red: Remove the activation key and contact
your STIHL servicing dealer.
There is a malfunction in the trimmer.
► Release the trigger.
The cutting attachmentstops rotating after a brief delay.
► If the cutting attachment continues to rotate: Remove the
activation key and contact your STIHL servicing dealer.
The trimmer has a malfunction.
11.2 Inspecting the Cutting Attachment
► Switch off the trimmer and remove the activation key.
0458-718-9621-A
A
► If the wear mark (A) on the underside of the PolyCut 2-2
head is visible: Have the PolyCut 2-2 mowing head
replaced by a STIHL servicing dealer.
► If the length of one of the blades, measured from the large
bore to the tip, is less than 'a' = 45 mm: Replace both
blades.
11.3 Checking the Built-In Battery
► Press the button.
The LEDs glow or flash.
► If the LEDs do not glow or flash: Do not use your trimmer
and contact your STIHL servicing dealer.
There is a malfunction in the built-in battery.
English
a
45
Advertenties
Hoofdstukken
Inhoudsopgave
