Advertenties
Beschikbare talen
Beschikbare talen
Intervention
Recharge the battery
Cleaning the machine and the motor
Cleaning and lubrication of the cutting means
Checking for any damage to the machine. If
necessary, contact the authorised service centre.
Checking the cutting means
Sharpening the cutting means
Replacing the cutting-means
* Refer to the battery/battery charger manual.
** The operation must be carried out by your Dealer or a specialised Service Centre
14. TROUBLESHOOTING
PROBLEM
1. The machine does not
start when the blade
control lever and safety
switch are pressed.
2. The motor shuts
down whilst working
3. The cutting means is
stationary when the
blade control lever
and safety switch
are engaged
4. The cutting means
overheats whilst working
5. The cutting means
comes into contact with
a line or electric cable
6. The cutting means
comes into contact
with a foreign body.
PROBABLE CAUSE
Battery is not inserted or
is inserted incorrectly
Low battery
Hedge trimmer is damaged
Battery is not inserted correctly
Low battery
Hedge trimmer is damaged
Insufficient blade lubrication
-
-
Frequency
After each use
After each use
After each use
After each use
After each use
-
-
Make sure that the battery is
inserted correctly (par. 7.2.3)
Check the battery status and
recharge if necessary (par. 7.2.2)
Do not use the hedge trimmer. Remove
the battery and contact a Service Centre.
Make sure that the battery is
inserted correctly (par. 7.2.3)
Check the battery status and
recharge if necessary (par. 7.2.2)
Do not use the hedge trimmer. Immediately
turn off the machine,
and
contact a service centre.
Turn off the machine, wait until the cutting
means is stationary, remove the battery
and lubricate the blades (par. 7.4)
DO NOT TOUCH THE BLADE AS IT
MAY BE LIVE AND BE EXTREMELY
DANGEROUS! Grasp the machine using
the insulated rear handgrip only and
position it at a safe distance from yourself.
Disconnect the current that powers the
severed line or mains cable and remove
the battery before freeing the blade teeth.
Turn off the machine,
–
inspect for damage;
–
check for and tighten any loose parts;
–
have any damaged parts replaced
or repaired with parts having
equivalent specifications.
EN - 11
Notes
par. 7.2.2
*
par. 7.3
par. 7.4
-
par. 8.1.1
par. 8.1.2
**
par. 8.1.3
**
SOLUTION
remove the battery
remove the battery and:
Advertenties
