Advertenties
Beschikbare talen
Beschikbare talen
Write the identification data of the
machine in the specific space on the
label on the back of the cover page.
IMPORTANT Quote the information on
the product identification label whenever you
contact an authorised service workshop.
IMPORTANT The example of the
Declaration of Conformity is provided
on the last pages of the manual.
3.4 MAIN COMPONENTS
The machine is composed of a series
of main components that have the
following functions (fig.1 ):
A. Motor: supplies the drive power
to the cutting means.
B. Blade (cutting means): the element
designed to cut the vegetation.
C. Front handgrip: used to handle the machine
and equipped with the safety switch.
D. Rear handgrip: used to handle the machine
and equipped with the main control buttons.
E. Blade protection (for machine
transport and handling): protects against
accidental contact with the cutting
means that can cause serious injuries.
F.
Battery (if it is not supplied with the machine,
see chapter 15 "Attachments on request"):
device that supplies electric current to the
tool; its specifications and regulations for
use are described in a specific manual.
G. Battery charger (if it is not supplied with
the machine, see chapter 15 "Attachments
on request"): device used to recharge the
battery; its specifications and directions for
use are described in a specific manual.
4. UNPACKING
IMPORTANT The safety regulations
to follow are described in chap. 2. Strictly
comply with these indications to avoid
serious risks or dangers.
Unpacking should be done on a flat
and stable surface, with enough space
for machine handling and its packaging,
always making use of suitable equipment.
1. Carefully open the packaging, paying
attention not to lose components.
2. Consult the documentation in the
box, including these instructions.
3. Remove the machine from the box.
4. Dispose of the box and packaging in
compliance with local regulations.
5. CONTROLS
5.1 BLADE CONTROL LEVER
(CUTTING MEANS)
The blade control lever (Fig. 3.A)
lets you start the blade.
The cutting means (Fig. 1.B) can only be started
by simultaneously pressing the blade control
lever (Fig. 3.A), the blade control lock button
(Fig. 3.B) and the safety switch (Fig. 3.C).
The cutting means stops automatically
when the lever is released.
5.2 BLADE CONTROL LOCK BUTTON
The blade control lock button (Fig. 3.B) lets
you press the blade control lever (Fig. 3.A).
5.3 SAFETY SWITCH
The safety switch located on the front
handgrip (Fig. 3.C) provides additional safety
since it must be held down with the blade
control lever to start the cutting means.
The cutting means stops automatically
when the safety switch is released.
5.4 REAR HANDGRIP RELEASE LEVER
The release lever (Fig. 3.D) is used to adjust
the rear handgrip (Fig. 1.D) to 3 different
positions in relation to the cutting means
to make trimming your hedges easier.
The handgrip must only be adjusted
when the machine is switched off. Never
keep your finger on the safety switch to
avoid accidentally enabling the machine.
6. USING THE MACHINE
IMPORTANT The safety regulations
to follow are described in chap. 2. Strictly
comply with these indications to avoid
serious risks or dangers.
EN - 5
Advertenties
