Advertenties
Beschikbare talen
Beschikbare talen
Compa III
Load Transfer Ribbon
NOTICE!
For the thermal transfer printing method it is necessary to load a ribbon, otherwise when using the printer in direct
thermal print it is not necessary to load a ribbon. The ribbons used in the printer have to be at least the same width
as the print media. In case the ribbon is narrower than the print media, the printhead is partly unprotected and this
could lead to early wear and tear.
NOTICE!
Before a new transfer ribbon roll is loaded, the printhead must be cleaned using printhead and roller cleaner
(97.20.002).
The handling instructions for the use of Isopropanol (IPA) must be observed. In the case of skin or eye contact,
immediately wash off the fluid thoroughly with running water. If the irritation persists, consult a doctor. Ensure
good ventilation.
•
Turn the lever (6) counterclockwise to lift up the printhead.
•
Slide the transfer ribbon roll (1) onto the rewinder (2) so that the colour coating of the ribbon faces downward when being
unwound.
•
Slide the roll (1) until il locks.
•
Hold the transfer ribbon roll (1) firmly and turn the knob on the rewinder (3) counterclockwise until the transfer ribbon is
secured.
•
Slide suitable transfer ribbon core (4) onto the transfer ribbon rewinder (5) and secure it in the same way.
•
Guide the transfer ribbon through the print unit as shown in the figure.
112
1
2
3
4
5
6
English
Advertenties
Hoofdstukken
