4. Switch off the toothbrush using the on/
off switch
7.
5. Moisten the bristles, apply some tooth-
paste, and only switch on the tooth-
brush 10 again when the brush head 1
is already in your mouth.
6. Slowly guide the brush head 1 from
tooth to tooth without exerting too much
pressure. Carefully clean all tooth sur-
faces, the inner surfaces of the teeth
and the tooth edges.
Figure A: the recommended brushing
time is at least 2 minutes, divided up
into 30-second periods for each area of
the mouth (bottom right, bottom left, top
right, top left). The toothbrush 10 indi-
cates these intervals by two brief inter-
ruptions.
NOTE: if the brush head 1 is pressed against
the teeth too hard, the LED 6 lights up red.
You should then reduce the pressure.
7. The toothbrush signals the end of a cy-
cle of 2 minutes with three short inter-
ruptions. Switch off the toothbrush using
the on/off switch
brush head 1 from the mouth only
when the toothbrush 10 has been
switched off.
NOTES:
•
We recommend that you replace the
toothbrush heads 3 every 3 months or
after infections (see "Ordering tooth-
brush heads" on page 11).
•
The indicator bristles 2 on the brush
head 1 slowly lose their colour during
use. The decolouration shows when the
toothbrush heads 3 should be re-
placed.
7. Remove the
9. Transport when
traveling
9.1 Transport lock
To secure the toothbrush 10 against acci-
dentally being switched on, activate the
transport lock.
•
Switching on the transport lock:
Hold down the on/off switch
the LED 6 flashes red three times.
•
If you try to switch on the tooth-
brush 10 with the transport lock activat-
ed, the LED 6 will flash red.
•
Switching off the transport lock:
Hold down the on/off switch
the LED 6 flashes red three times.
9.2 Travel case
The travel case 14 has space for the tooth-
brush 10 and 2 toothbrush heads 3.
•
Open the travel case 14 by pressing
on the pressure cap 15.
•
Close the travel case 14 by carefully
pressing the lid down until it audibly
clicks into place.
7 until
7 until
9
GB